MecArmy PT60 9600 Lumen

PT60 User Manual

Patented Ultra Bright USB Rechargeable Flashlight

Primary Features:

• Uses 16 CREE XP-G2 S4 LEDs, Max output up to 9600 lumens
• Micro USB Intelligent charging inputs; compatible with any USB port
• 3 available Micro USB charging ports, allows quick charge in 3 hours
• DC 5V/ 2A USB output, can be used as a power bank
• Accurate battery capacity indicators
• Charging and fully charged indicators
• Max 58WH battery cell capacity, built-in capacity up to 13600mAh
• 18650 li-ion battery pack, max running time up to 26 days for PT80
• Max beam distance 415 meters
• Portable handle available as an accessory
• Pure copper and gold plating circuit boards
• Integration and high efficiency optical lens
• Four independent constant current drivers
• Built-in temperature testing system, keeps the temperature at 45 degrees
• Aggressive head bezel for self defense
• High efficient heat dissipation design
• Rugged pineapple texture for better grip; anti-roll
• Tail stand capability
• Gun mount available as an accessory
• Standard 1/4 inch Tripod mount4
• Constructed from aero grade aluminum alloy, with HAIII hard-anodization
• IPX-8 water resistance

PT60 Specification

LED: 16 CREE XP-G2 S4 LEDs

Output & Runtime

Dimensions

Length: 124mm/ 4.88in

Head diameter: 75mm/ 2.95in

Body diameter: 52mm/ 2.05in

• Weight: 450g/ 15.87oz (excluding battery pack)

Battery pack weight: 200g/ 7.05oz

• Working voltage：6V- 10V
• Charging time: 3 hours at 3A
• Accessory: User manual, 1×18650 Battery pack (comprising 4x18650 protected batteries), lanyard, O-rings, holster
• Selectable accessories: handle, gun amount

Operation

• From OFF: 1 click for ON (Low mode)
• From OFF: 2 click for Turbo
• From OFF: 3 click for STROBE
• From STROBE: Long press (> 1 second) for SOS
• From OFF: Press and hold for Momentary ON (Turbo), release to turn off
• From ON: 1 click for OFF
• From ON: Press and hold to cycle through modes (Low/Med/High/Turbo)

• Turbo Mode: In Turbo mode the 16 CREE XP-G2 LEDs run at the highest brightness and discharge rate. High quality batteries are recommended for peak performance.

This is a high-performance light and generates significant heat in Turbo mode. To protect the light and user, output in Turbo will drop to 70% of maximum brightness after 3 minutes. Output will also be adjusted by real time temperature monitoring

Charging

Carefully unscrew and remove the light’s head, and connect USB charging cable(s) as shown in the diagram below, a combination of the 3 micro USB ports may be

used

Charging time: 5V/ 1A

8 hours/ 1 cable

4 hours/ 2 cables

3 hours/ 3 cables

Charging time: 5V/ 2A

6 hours/ 1 cable

3 hours/ 2 cables

The auto testing circuitry controls the battery pack charging from 500mA to 3A inputs over three Micro USB ports.

Charging Indicator

When charging, the white circle indicator turns red; when fully charged, it will go out

During charging, the battery capacity will be displayed as four stages on the green indicator;

1 bar indicates 25% capacity; 2 bars indicates 50%; 3 bars indicates 75%; 4 bars is 100% capacity. Battery level may also be checked at any time by pressing

the "push" button, the indicator will turn off after 6 seconds.

Power Bank output

The standard USB socket can be used as a power bank. Connect a USB lead to your device and press "push" to start charging. Output will stop after 10 seconds if there is no load

WARNING:

• Do not point the light at human or animal eyes
• Do not look directly into the light when it is switched on
• Do not permit children to use the flashlight unsupervised

Maintenance

• Remove battery pack when stored for extended periods
• Replace and lubricate O-Rings as needed to maintain IPX-8 rating
• Every 6 months, thread should be wiped with a clean cloth followed by a thin coating of silicon-based lubricant